Upgrade Five to Polaris¶
In this section are listed the manual steps to do when migrating from Five to Polaris.
On XiVO CC¶
The xivo-solutions-VERSION no longer exists. The
xivocc-installer package is now located in xivo-VERSION distribution.
You have to update your source list accordingly.
Remove apt source list file:
Add new source list file:
echo "deb http://mirror.xivo.solutions/debian xivo-polaris main" > /etc/apt/sources.list.d/xivo-dist.list
On XiVO PBX¶
Accept new cel.conf: if you are asked by
xivo-upgradeinstaller, you must choose to replace the
cel.conffile or ensure that its content correspond to these defaults.
Finish to remove xivo-ctid-ng and xivo-websocketd:
apt-get purge xivo-websocketd xivo-ctid-ng
Add writetimeout parameter to the the
[xuc] secret = ... deny = ... permit = ... read = ... write = ... writetimeout = 10000
You MUST update:
- Snom phones to use plugin version >=2.2 to be able to use CTI Transfer (UC Assistant or CCAgent),
- Yealink phones to use plugin with v81 firmware to be able to use CTI Transfer (UC Assistant or CCAgent).
The WebRTC call limit was raised to 2 (to enable transfers). The simultcalls parameter of a WebRTC user should be set to 2 also.
On XiVO CC¶
Update new fingerboard:
xivocc-dcomp stop fingerboard docker rm xivocc_fingerboard_1 xivocc-dcomp up -d
Import new reports as described in SpagoBI post install step
Then, you should also remove old sample reports:
Go to Reports menu and delete all reports which are located under Racine -> Sample
Once all reports are deleted inside these folder you can go to Functionalities Management menu as shown in following screenshot:
From here, you can delete empty folders by clicking on it
At the end you should have a report folder list, that contains only Rapports and Accueil folder as seen here (unless you have some specific customer report):